SSD20x System Development Manual
打印
首页
目录 搜索
  • Summarize
  • Download Resources
  • Hardware parameters
  • Chapter 1 Programming Environment Setup
    • Downloal Source Code
    • Install The Cross Compilation Tool Chain
    • Install The SDK Source Code
    • Install and Compile the Required Lib & Tool
  • Chapter 2 Compile the Source Code
    • Configure the compile script
    • Start build
    • Compile builderroot
  • Chapter 3 System Burning
    • Uboot Burning
      • ISP burning tool driver download
      • ISP Burn
      • ISP burning uboot encountered problem resolution
    • Kernel Burn
      • ETH Burn
      • USB Burn
      • SD Card Burn
  • Chapter 4 About Debug
    • Analysis of ETH Burning Principle
    • Update uboot and kernel
    • Update rootfs
  • Chapter 5 Source Code Architecture Analysis
    • Generation of uboot
    • Generation of Kernel
    • Generation of Rootfs
  • Chapter 6 File System Customization
  • Chapter 7 Fastboot Mode
  • Chapter 8 Adjustment of Ram Configuration
  • Chapter 9 Adjustment of Flash Partition
  • Chapter 10 LCD Screen Configuration
    • RGB Screen
      • 7-inch development board RGB
    • MIPI Screen
    • verification
  • Chapter 11 Bootlogo and Boot Animation
    • BootLogo
  • Chapter 12 The use of the GPIO
    • Uboot using GPIO
    • Drivers using GPIO
    • Userspace operation GPIO
  • Chapter 13 UART configuration
    • The correspondence between serial port and device
    • General serial port configuration
    • Serial port configuration with flow control
    • RS485 serial port configuration
    • Test
  • Chapter 14 SPI configuration
  • Chapter 15 I2C configuration
  • Chapter 16 PWM configuration
  • Chapter 17 WIFI configuration
    • The load driver
    • The STA model
    • AP mode
  • Chapter 18 Internal RTC configuration
    • Open the internal RTC
    • Operation internal RTC
  • Chapter 19 WATCHDO configuration
    • Load Watchdog Driver
    • test
    • Add Watchdog Service
  • Chapter 20 Audio configuration
    • LineOut
    • DMIC
    • AMIC
    • I2S
  • Chapter 21 Use of the SYS API
  • Chapter 22 The transplantation of QT
    • TSLIB source code compilation
    • Qt source code compilation
    • Initialization screen
    • Validation
    • Transplant
  • Chapter 23 Master film production (factory system
    • Making Mother piece of mirror
    • Burn validation
  • Chapter 24 The use of SAR
    • The KERNEL configuration
    • SAR control
暂无相关搜索结果!

本文档使用 MinDoc 发布

Download Resources

Download Resources

IDO-SSD20X Baidu Cloud Link:
Link:https://www.dropbox.com/sh/r3q2l3ytuuybuza/AAAsKuFNYwNJs2PsnOJwZclOa?dl=0

文档更新时间: 2023-09-01 14:14   作者:Aeeditor

项目分享

扫一扫手机阅读

项目分享

扫一扫手机阅读